Tarkett Flooring Installation Instructions

To get started you need to do the following.

Tarkett flooring installation instructions.

For installation room temperature should always be above 15 c or 18 c for linoleum. Saw pencil tape measure vacuum cleaner step 1 prepare your subfloor to ensure a smooth installation it is important to prepare the surface. With the new 2 lock angle locking system parquet and laminate flooring have become very easy to install with only a few tools required. Released may 2013 page 1 of 2 expressions vct inst 050713.

Vinyl composition tile flooring. The end joints of the planks in the first row. Do not install damaged planks. Tarkett flooring may be installed over radiant heated floors provided the operating temperature does not exceed 85º f 29 4ºc.

Pvc or. Tarkett will not accept responsibility for claims on flooring installed with obvious defects. Tarkett flooring and adhesives must be site conditioned at room temperature for a minimum of 48 hours prior to during and after installation. Measure distance between wall and surface of full plank.

Place 1 4 6 3mm spacers between the short and long side of the planks and the wall use 1 2 12 7mm spacers for. Before installation sheets and tiles should relax minimum 24h out of packaging. Remove your vinyl floor from its packaging and keep it in the room where it is to be. Check the rules in your country.

The tongue side of the plank. These instructions combined with our adhesives and flooring products create a system. Room temperature must be maintained between 65 ｰ workmanship is employed in the and 85 ｰf 18 ｰ and 30 ｰc with hvac system operating. Do not fasten them through the laminate flooring.

In most cases you need to remove the existing floor covering. Install transition reduction profiles where needed. If the heating pipes are too close to the flooring the flooring may discolor next to the pipe work. Installation begin laying planks from the left side of the starting wall and work to the right side.

Rolls and tiles must be stored during 48 hours before starting the operation. Those temperatures could be different. Ensure the subfloor is dry clean and flat. Subtract 1 4 6 3mm or 1 2 12 7mm depending on the size of the spacer used from this measurement to allow for the spacer.

Do not use a hammer and tapping block to install planks. Tarkett laminate8 installation instructions 2 locktarkett laminate9 installation instructions 2 lock finish remove the spacers from the perimeter of the room. If this measurement is less than 12 20 3cm the length of first plank in the row must be cut. Heating pipes shall be at least 2 inches 50 8mm below the surface of the concrete.